Lenze 8400 BaseLine C - Manual (Page 238)

Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
238
10 Parameter reference
10.2 Parameter list | C00007
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00007
Parameter | Name:
C00007 | Control mode
Data type: UNSIGNED_16
Index: 24568
d
= 5FF8
h
Selection of how the application is to be controlled.
Selection list
(Lenze setting printed in bold) Info
0 Wiring has changed This display appears when the preset configuration has
been reparameterised via the connection parameters.
10 Terminals 0 The technology application is controlled via the digital
input terminals of the controller:
• DI1 = fixed setpoint 1/3
• DI2 = fixed setpoint 2/3
• DI3 = activate DC injection braking
• DI4 = change of direction of rotation
12 Terminals 2 The technology application is controlled via the digital
input terminals of the controller:
• DI1 = fixed setpoint 1/3
• DI2 = fixed setpoint 2/3
• DI3 = quick stop
• DI4 = change of direction of rotation
14 Terminals 11 The technology application is controlled via the digital
input terminals of the controller:
• DI1 = change of direction of rotation
• DI2 = activate DC injection braking
• DI3 = motor potentiometer: Higher speed
• DI4 = motor potentiometer: Lower speed
16 Terminals 16 The technology application is controlled via the digital
input terminals of the controller:
• DI1 = fixed setpoint 1/3
• DI2 = fixed setpoint 2/3
• DI3 = CW rotation/quick stop
• DI4 = CCW rotation/quick stop
20 Keypad The technology application is controlled via the keypad:

C00002 : Device commands
 C00003 : Status of last device command
 C00727 : Executing control commands
 C00728 : Selecting analog setpoints
 Increase speed
 Reduce speed
21 PC The technology application is controlled via the "Free pa-
rameters" of the controller (PC control).
30 CAN The technology application is controlled by means of
CAN-PDOs via the system bus "CAN on board".

System bus "CAN on board"
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1