Lenze 8400 BaseLine C - Manual (Page 35)

Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
35
3 Commissioning
3.4 Commissioning with the »Engineer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Parameterise application
On the right of the Application parameters tab, the parameters of the application are arranged:
1. Select the required control mode in the Control mode ( C007 ) list field.
• The corresponding wiring diagram is displayed in a pop-up window if you click the button
right to the list field.
• For a detailed description, see chapter entitled " Terminal assignment of the control modes ".
( 139)
2. Optional: Use process controller.
• For this purpose select the required operating mode in the L_PCTRL_1: Operating mode
( C242 ) list field.
• For a detailed description see the function block L_PCTRL_1 . ( 312)
• The parameterisation dialog of the process controller can be accessed via the Process
controller button.
3. Optional: Use motor potentiometer.
• For this purpose, select "1: On" in the L_MPot_1: Use ( C806 ) list field.
• For a detailed description see the function block L_MPot_1 . ( 305)
• The parameterisation dialog of the process controller can be accessed via the Motor
potentiometer button.