GAI-Tronics TMA Version 7.5.0 Telephone Management Application (TMA) User Guide (Ver. 7.5.0 and newer) - Manual (Page 36)

Pub. 42004-479B
Telephone Management Application (TMA) User Guide Page 33 of 128
e:\standard ioms - current release\42004 instr. manuals\42004-479b.doc
03/14
Parameter Function
Call-In Time The Call-In Time sets the time of day the telephone will call in, and can be set in 1-
minute increments.
Type B telephones only: During a scheduled call-in, the telephone updates TMA
with the next scheduled call-in time. In the event a telephone does not complete a
scheduled call-in, the telephone defaults to performing to a daily call-in mode.
Number of Call-
In Retries The Number of Call-In Retries directs the telephone to make additional call-in
attempts (or retries) if the first attempt was unsuccessful. Each additional call-in
attempt occurs at 50-second intervals and is not determined by the Call-In Retry
Delay below.
Call-In Number The Call-In Number has a group of three fields. The first number is the primary
number the telephone will dial at scheduled (or unscheduled) call-in times.
If the primary call is unsuccessful, the telephone cascades to the second number in an
attempt to complete the maintenance call. If the second number is also unsuccessful,
the third number will be attempted.
Fault Indicators
A telephone can report status for several inputs, which can be internal or external to the telephone. The
function of an input can be assigned a “Common Name” via drop-down list selections, which will appear
on reports. A “Fail” (fault) condition is reported for a stuck (closed) contact. The “Fault Indicators”
properties form is shown below followed by explanations of the available selections.
Fault Indicator Numbers