GAI-Tronics TMA Version 7.5.0 Telephone Management Application (TMA) User Guide (Ver. 7.5.0 and newer) - Manual (Page 46)

Pub. 42004-479B
Telephone Management Application (TMA) User Guide Page 43 of 128
e:\standard ioms - current release\42004 instr. manuals\42004-479b.doc
03/14
Table 15. Other Fields and Check-Box Selections
Parameter Function
Call Progress
Tone Blocking
Time When set to a value greater than 100, the telephone will detect North American
Call Progress tones (ring back, busy, fast busy). For other values, this parameter
specifies the time (in seconds) at the start of the call during which the telephone
will ignore these tones, which disables the phone’s ability to redial a call on the
“no answer” or on the “busy” condition. This can be useful when the telephone
system does not meet North American standards.
CR_LED
Confirmation
Tone When checked, the telephone transmits a brief confirmation tone when the Call
Received LED becomes active solid.
Send DTMF Tone
After Attention
Star Detection When checked, the telephone transmits a brief confirmation tone after it detects the
first “Star” digit of each “Star” command.
Use Low DTMF
for S/N When checked, the telephone transmits the serial number prefix using DTMF
numeric digits (0–9) instead of alphabetic digits (A–D). Use of this function is
applicable only to phones operating behind a cellular interface.
Transmit 1st
Autodial # on
Incoming Call When checked, the telephone transmits the Primary Autodial number for the
E
MERGENCY
push button when it accepts an incoming call. Remote programming
is disabled.
Disable Busy Tone
Counting SMART Telephones automatically end a call attempt and retry when an auto-dial
or ringdown operation results in several cycles of a Busy or Fast-Busy signal. In
addition, RED ALERT
® emergency telephones end a keypad call automatically
after detecting six cycles of Busy or Fast-Busy.
When checked, this counting/retry automation is disabled. (This disable option
applies only to telephones having firmware version greater than 301.)
Disable Ringback
Counting For
Voice Call SMART Telephones automatically end a voice call attempt and retry when an
auto-dial call results in many cycles of Ringback signal.
When checked, this counting/retry automation is disabled. (This disable option
applies only to telephones having firmware version greater than 301.)
Skip Dial Tone
Detection When checked, the telephone auto-dials its programmed number without waiting to
detect dial tone. Using this option may result in improper dial sequences on some
PABX systems.
(This disable option applies only to telephones having firmware version greater
than 301.)