Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 140)

140 K2 Storage System Instruction Manual July 3, 2007
Chapter 4 Installing the Level 3 Storage System
• Configure SNMP properties so the trap destination points to the NetCentral server
PC. Use standard Windows procedures. If you are not using the SNMP community
name “public”, configure the community name and set permissions to RW. Also
make sure that the Authentication trap is enabled.
Also refer to “K2 Media Server description” on page 287 .
Setting up the L3 RAID chassis
Do the following to prepare the L3 RAID storage devices:
• Install the chassis in its permanent location. Refer to the L3 RAID Instruction
Manual for rack mount instructions.
• “Assign Fibre Channel address ID” on page 141 .
• “Connect the L3 RAID chassis” on page 141
• “Assign chassis address on Expansion chassis” on page 142 .
• “Power on the L3 RAID chassis” on page 144
In addition, you will configure network settings, SNMP settings, and bind LUNs.
These tasks are part of the K2 System Configuration application and Storage Utility
procedures later in this chapter. The process of binding LUNs can take a significant
amount of time—as much as eight hours—so you might want to put priority on the
tasks necessary to start the LUN binding process, then catch up with other tasks while
the LUNs are binding.
Also refer to “K2 Level 3 RAID storage description” on page 292 .