Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 227)

July 3, 2007 K2 Storage System Instruction Manual 227
Level 3R system power-off procedure
3. Take note of which is the primary K2 Media Server and which is the backup K2
Media Server. The order in which you put servers back into service when you
power up the K2 Storage System is dependent on their primary/backup roles at the
time when you power down the K2 Storage System.
4. For the backup K2 Media Server, click Stop . This takes the server out of service.
5. Shut down the backup K2 Media Server, if it does not shut down automatically.
6. For the primary K2 Media Server, click Stop . This takes the server out of service.
7. Shut down the primary K2 Media Server, if it does not shut down automatically.
8. For your other two K2 Media Servers that are the FTP servers, first shut down the
backup, then the primary.
9. Power-off the primary RAID controller chassis. If expansion chassis are
connected, make sure the power-off of the controller chassis is prior to or
simultaneous with the power-off of its connected expansion chassis. Wait
approximately 30 seconds for the disk drives to spin down before proceeding.
10.Power-off all Ethernet switches.
11.Power-off the control point PC and/or the NetCentral server PC, if necessary.