Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 246)

246 K2 Storage System Instruction Manual July 3, 2007
Chapter 6 Installing the Nearline Storage System
5. Set Spanning Tree to On and click Apply Changes .
6. Click Port Configuration .
7. If you do not need trunks, such as on a one-switch system, skip to the next step in
this procedure. If you need trunks, such as on a two-switch system with ISLs, do
the following:
a. Select (Ctrl + Click) the trunked ports. Typically the trunked ports are at the
bottom of the list. In the configuration for 10 Gig ISLs, two of the ports at the
bottom of the list are labeled Trk1.