Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 278)

278 K2 Storage System Instruction Manual July 3, 2007
Chapter 6 Installing the Nearline Storage System
3. If you got a “The V: will not be available until this device is rebooted…” message
on the File System Server Configuration page, after the K2 Media Server restarts,
do the following:
a. In the K2 System Configuration application tree view, under the K2 Media
Server select the File System Server node.
The File System Server Configuration page appears.
b. Click Check and verify that the V: drive is shared. This is required for NAS
server functionality.
4. Repeat this procedure for remaining Nearline K2 Media Servers, if any.
Your configurations for the nearline K2 Storage System are complete.
Basic operations for nearline storage
Use the following procedures as you work on your Nearline storage system:
• “Nearline system power-off procedure”
• “Nearline system power-on procedure”
• “Using FTP for file transfer”
For other procedures refer to “Administering and maintaining the K2 Storage
System” on page 321 .
Nearline system power-off procedure
Use the following sequence to power-off the Nearline storage system.
1. Stop all FTP streams or other media operations on the nearline storage system.
2. Shut down the K2 Media Servers.
3. Power-off the primary RAID controller chassis. If expansion chassis are
connected, make sure the power-off of the controller chassis is prior to or
simultaneous with the power-off of its connected expansion chassis. Wait
approximately 30 seconds for the disk drives to spin down before proceeding.
4. Power-off all Ethernet switches.
5. Power-off the control point PC and/or the NetCentral server PC, if necessary.
Completing the
Configuration Wizard Click Finish . The wizard closes. The K2 Media Server restarts. Do not
proceed until restart processes are finished. If you are not sure if startup
is complete, wait 10 minutes.
On this page… Do this…