Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 213)

July 3, 2007 K2 Storage System Instruction Manual 213
Configuring the server 1A - Part 2
RAID 1 LUN as a journal stripe. You can distinguish RAID 1 LUNs from media
LUNs by the value in the Number of Sectors column.
6. Click OK . The Configuration File dialog box opens.
The configuration file for the media file system is displayed. You can verify media
file system parameters by viewing this file. Do not edit this file. Click
Accept .
A “…Please wait…” message box displays progress and a “…succeeded…”
message confirms the process is complete.
7. A message informs you that you must restart the K2 Media Server, however the
restart at the end of the Configure K2 Server wizard suffices, so you do not need to
restart now.
8. Close the Storage Utility.
NOTE: Do not attempt to start K2 Media Clients or otherwise bring the K2 Storage
System online until instructed to do so later in this chapter.
9. Continue with the next procedure.
Configuring the server 1A - Part 2
1. Return to the Configure K2 Server page from which you launched Storage Utility
and proceed as described in the following table: