Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 249)

July 3, 2007 K2 Storage System Instruction Manual 249
Setting up the K2 Media Server
Dell 2850 PowerEdge server
Dell 2950 PowerEdge server
Do not connect the iSCSI ports. They are not used for the Nearline storage
system.
Connect the motherboard GigE port 1 and GigE port 2 to control ports on the
GigE switch.
Connect one of the Fibre Channel ports to the RAID storage device.
• Assign a control network IP address to GigE port 1. Use standard Windows
procedures. Refer to “Networking tips” on page 56 .
• Change the hostname. Use standard Windows procedures.
• Configure SNMP properties so the trap destination points to the NetCentral server
PC. Use standard Windows procedures. If you are not using the SNMP community
name “public”, configure the community name and set permissions to RW. Also
make sure that the Authentication trap is enabled.
Also refer to “K2 Media Server description” on page 287 .
3
2
1
iSCSI interface
Power
Keyboard/Mouse
GigE
Fibre Channel
VGA monitor
GigE
(FTP) (control)
ports
port 1
(USB)
Serial port
port 2
(not used)
PCI 1
PCI 2
PCI 3
Serial port
VGA monitor
Fibre Channel
Power supply Power supply
Keyboard/Mouse
(USB)
GigE
port 2
(FTP) GigE
port 1
(control)
iSCSI
interface
ports
(not used)