Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 284)

284 K2 Storage System Instruction Manual July 3, 2007
Chapter 7 Description of K2 Storage Devices
Control point PC description
A control point PC runs applications from which you operate, configure, and monitor
the K2 Storage System. You can have one or more PCs that provide control point
functionality. You must have at least one control point PC on which you install and
run the K2 System Configuration application.
The primary applications that run on a control point PC are as follows:
• The K2 System Configuration application
• Storage Utility
• AppCenter
• NetCentral
Refer to Chapter 8, Overview of K2 Storage Tools and the K2 Media Client User
Guide for descriptions of these applications.
In addition, you can use the control point PC for the following applications:
• QuickTime
• Adobe Acrobat Reader
• Windows Remote Desktop Connection
You can purchase a control point PC from Grass Valley. In this case the PC has all
the above software pre-installed at the factory. When you receive the PC it is ready to
install on the K2 Storage System control network and begin using with minimal
configuration. Refer to the K2 Media Client System Guide for rack mount instructions.
You can also build your own control point PC by installing and configuring software
on an existing PC. Refer to the K2 Media Client System Guide for specifications and
instructions.