Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 User Manual
Page 33
Advertising
July 3, 2007
K2 Storage System Instruction Manual
33
Setting up the Level 2 GigE switch
5. Set Spanning Tree to
On
and click
Apply Changes
. If prompted, log in with the
switch’s administrator username and password.
6. Click
Port Configuration
.
7. If you do not need trunks, such as on a one-switch system, skip to the next step in
this procedure. If you need trunks, such as on a two-switch system with ISLs, do
the following:
a. Select (Ctrl + Click) the trunked ports. Typically the trunked ports are at the
bottom of the list. In the configuration for 10 Gig ISLs, two of the ports at the
bottom of the list are labeled Trk1.
Advertising