Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 313)

July 3, 2007 K2 Storage System Instruction Manual 313
Restoring from the generic recovery disk image on E:
procedure.
14. Select Database (D:) and then click Next .
The Restored Partition Location page opens.
15. Select Database (D:) and then click Next .
The Restored Partition Type page opens.
16. Leave the selection at Primary and then click Next .
The Restored Partition Size page opens.
17. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual D: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next .
The Next Selection page opens.
18. Select No, I do not and then click Next .
The Restore Operation option page opens.
19. Do not make any selections. Click Next .
The “…ready to proceed…” page opens.
20. Verify that you are restoring the correct partition or partitions. Click Proceed .
The Operation Progress page opens and displays progress.
21. When a “The data was successfully restored” message appears, click OK .
22. Click Operations | Exit to exit the Acronis True Image program.
The K2 Media Server restarts automatically.
23. Remove any CD currently in the CD drive while the K2 Media Server is shutting
down.
24. Upon restart the Windows Setup Wizard automatically opens. Do Windows setup
as follows:
a. Enter in Windows Product Key and click Next .
The Product Key is on a sticker on the top of the machine near the front right
corner.
b. Enter the name of the machine.
For a K2 Media Server name, enter the Serial Number (located at right side and
rear).
The password is pre-set to the factory default. Leave the password as is.
c. Click Next
d. Set Time and click Next .
Windows loads network components and restarts the K2 Media Server.
Upon restart, a Found New Hardware wizard and/or messages about services/
drivers can be displayed. This is because K2 software is not yet installed. You can
dismiss these wizards or messages.