Emerson Liebert CRV 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 C R 0 2 0 R A 1 C 7 S D 1 8 1 1 E L 1 0 P A - Manual (Page 21)

Prepare the Liebert CRV for Installation
13 Liebert ® CRV ™
4.0 P
REPARE THE
L
IEBERT
CRV
FOR
I
NSTALLATION
1. Open the display door and remove the lower front baffle panel using a 10mm nutdriver or T30
Torx Bit to prepare for installation.
2. Open the rear panel, referring to Figure 10. The documents are located inside the display door.
3. After the Liebert CRV is in its final installation position, adjust the four base supports, or feet,
with an adjustable wrench. Ensure that the unit is level to avoid corrosion or health hazards
caused by condensate accumulation.
a. Turning the base supports, or feet, clockwise, will extend them, lifting the unit one corner at a
time.
b. Tighten the nut on the top of each adjustable foot, inside the Liebert CRV, to lock the feet.
Figure 12 Adjust leveling feet
Adjust the
height of the
feet
Tighten this nut after
the foot is adjusted to
the desired height