Emerson Liebert CRV 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 C R 0 2 0 R A 1 C 7 S D 1 8 1 1 E L 1 0 P A - Manual (Page 51)

Startup
43 Liebert ® CRV ™
To adjust the baffles:
1. Open the door containing the Liebert iCOM
® display.
2. Remove the two screws holding a baffle panel segment in place.
3. Slide out the baffle segment.
4. There is one screw on each side of the baffle, as shown in Figure 31. Remove the screws and
rotate the baffle segment around its horizontal axis to change the airflow direction.
5. Reinsert the baffle segment and reinstall the screws.
Figure 31 Adjust the baffles to ensure correct airflow direction
A blocker plate inside the display door should also be adjusted to direct air towards the racks the
Liebert CRV is intended to condition. The blocker plate can be installed on the left or right side of the
display door, or it can be removed to discharge air left and right.
1. Open Liebert
CRV Display Door
Inside view, showing
baffle removal for changing
airflow direction
2. Remove two bolts
3. Tilt and lift
baffle panel
For proper operation, the baffles
must be installed so the discharge
air points upward
DPN001863
Pg. 1, Rev. 2