Yokogawa digitalYEWFLO (DY) - Manual (Page 34)

<5. BASIC OPERATING PROCEDURES>
5-6
IM 01F06A00-01EN
5.4 Setting Mode
The setting mode is used for checking parameters
and rewriting data. The following is an overview of
the setting mode.
NOTE
• Refer to Section 6.3 “Parameters List” and
Section 6.4 “Parameters Description” on how
to change setting.
5.4.1 Display Confi guration of Setting
Mode
Simple parameter sheet
In this sheet, a setting fl ow chart and the parameter
list required to operate digitalYEWFLO is indicated.
SET
INC SHIFT
F0506.ai
Item number
Change item number using
“SHIFT” key and “INC”key.
Data number
Change the data number
using “SHIFT” key and
“INC” key.
SET
Flowrate Display Mode
Parameter Setting Mode
Select Item
Set Data
Check Setting Data
Fix Setting Data
SHIFT+SET
SET SHIFT+SET
SET
SET
SHIFT or INC
SHIFT : Menu Item Number
INC : Inc. Menu / Item Number
INC : Inc. Data Number
Select Type
Numeric Value Setting Type
SHIFT : Move Cursor
INC : Inc. Numeric Value
F0507.ai
Figure 5.3 Indicator Confi guration and Parameter
Setting Procedure
• When completing setting, press “SHIFT” key
and “SET” key simultaneously. The mode
move to the “display mode”.
IMPORTANT
After setting a parameter, keep the power on for
at least 30 seconds.
If the power of fl owmeter is turned off, a
parameter setting is released.