Yokogawa PR300 Power and Energy Meter - Manual (Page 78)

<Toc> <Ind> <4. PC Link Communication Protocol>
4-17
IM 77C01E01-10E
4.4 Sample Program
4.4.1 Example of BASIC Program for Send and Receive
This section shows an example of a command sending and response receiving program
created with F-BASIC*
2 for PC/AT* 1 (or compatible machines).
*1 PC/AT is the product of IBM Ltd.
*2 F-BASIC is the product of Fujitsu Ltd.
Example of the Program Created Using F-BASIC Version 6.3
Communication Conditions Baud rate: 9600bps
Parity: None
Data length: 8 bits
Stop bit: 1 bit
Protocol: PC link (without checksum)
STX$=CHR$(2) ‘Define
ETX$=CHR$(3) ‘Define
CR$=CHR$(13) ‘Define
LF$=chr$(10) ‘Define
RCVCHR$=”” ‘Initialize receive character string
STOPFLAG=0 ‘Initialize end flag
‘
SEND$=STX$+”01010WRDD0001,02"+ETX$ ‘Create character string for send
‘
BAUD 0,9600 ‘Set a communication baud rate
open “COM0:(F8N1N7)” as #1 ‘Open a communication port
‘
interval 5 ‘Set timeout timer
on com(0) gosub *RECEIVECHR ‘Specify interruption processing
during receiving
on interval gosub *TIMEOUT ‘Specify interruption processing
at timeout
‘
print #1,SEND$ ‘Send
com(0) on ‘Permit interruption during receiving
interval on ‘Start timer
‘
while STOPFLAG=0 ‘Wait for receive end or timeout
waiti
wend
‘
com(0) off ‘Permit interruption during receiving
close #1 ‘Close the port
‘
print “>”+SEND$ ‘Display sent character string
on screen
print “<“+RCVCHR$ ‘Display received character
string on screen
end
‘