NORD Drivesystems BU0750 - Manual (Page 101)

7.6 Control clamps
BU 0750 GB-3311 Subject to technical amendments 101
Parameter Setting value / Description / Note
Parameter
set
Available with option
P420 Function of digital input 1
BSC STD MLT
BUS
0 ... 48
[ 1 ]
Enable right as factory setting
Various functions can be programmed. These can be seen in the following table.
P421 Function of digital input 2
BSC STD MLT
0 ... 48
[ 2 ]
Enable left as factory setting
Various functions can be programmed. These can be seen in the following table.
P422 Function of digital input 3
BSC STD MLT
0 ... 48
[ 8 ] Parameter set switching as factory setting
Various functions can be programmed. These can be seen in the following table.
P423 Function of digital input 4
STD MLT
0 ... 48
[ 4 ] Fixed frequency 1 as factory setting
Various functions can be programmed. These can be seen in the following table.
P424 Function of digital input 5
MLT
0 ... 25
[ 0 ] No function as factory setting
Various functions can be programmed. These can be seen in the following table.
P425 Function of digital input 6
MLT
0 ... 25
[ 0 ] No function as factory setting
Various functions can be programmed. These can be seen in the following table.