NORD Drivesystems BU0750 - Manual (Page 61)

4.4 Functions of the ParameterBox
BU 0750 GB-3311 Subject to technical amendments 61
Display
After the ParameterBox is connected and the mains voltage for the inverter is switched on, an automatic "Bus
scan" is performed. The ParameterBox identifies the connected frequency inverter(s). The frequency inverter
type and its actual operating status can be seen in the following display.
750E 11.0kW/3 POS STD 1
> NORDAC <
Frequency inverter
ONLINE FI1 P1 EReady
Actual status of
the inverter
Inverter type
In the standard display mode, 3 operating values and the actual frequency inverter status can be displayed
simultaneously.
The operating values displayed can be selected from a list of 8 possible values (in Menu>Display</>Values for
display< P1004).
750E 11.0kW/3 POS STD 1
Fi/Hz U/V I/A
45.0 190 1.4
ONLINE FI1 P1 R RUNNING
Current actual values for
the selected operating
values and their
applicable units
Current
ParameterBox status
Inverter selected Active parameters
in inverter
Actual status of the
inverter
Inverter type
Menu structure level
Special extension unit
Customer interface
NOTE The digital frequency setpoint is factory set to 0Hz. To check whether the motor is working, a
frequency setpoint must be entered with the key or a jog frequency via the respective menu
level >Parameterise<, >Base parameters< and the respective parameter >Jog frequency<
(P113).
Settings should only be implemented by qualified personnel, strictly in accordance with the
warning and safety information.
CAUTION: The drive may start immediately after pressing the START key !