NORD Drivesystems BU0750 - Manual (Page 66)

NORDAC SK 750E Manual
66 Subject to technical amendments BU 0750 GB-3311
Screen layout during parameterisation
If the setting of a parameter is changed, the value flashes until it is confirmed with the ENTER key ( ). To
load the factory setting of the parameter to be edited, both VALUE keys ( and ) must be pressed
together. To store this change, the setting must also be confirmed with the ENTER key.
If the change is not to be saved, pressing of a VALUE key ( or ) calls up the previously saved value
and the parameter is exited by pressing a VALUE key again.
P102 PS1 3
Start-up time
2.90 s
ONLINE FI1 P1 E BLOCK
Menu structure
level
Actual parameter data set
to be edited
Actual parameter to be
edited (Text)
Current
ParameterBox
status
Selected frequency
inverter
Active parameter data set
in control medium
Status of the
frequency inverter
Actual parameter
value
Actual parameter to be
edited (No.)
Note:
The display in the lower line is used to display the actual status of the ParameterBox and the
frequency inverter being controlled.