NORD Drivesystems BU0750 - Manual (Page 65)

4.4 Functions of the ParameterBox
BU 0750 GB-3311 Subject to technical amendments 65
Parameter setup with the ParameterBox
To enter the parameterisation mode, the menu group >Parameterisation< must be selected in the menu level
1. Pressing the ENTER key ( ) opens the parameter level of the connected frequency inverter. The
following diagram shows how the control elements of the ParameterBox are used for the parameterisation of a
frequency inverter.
Simultaneous operation
→ Load factory settings of
parameter
Up one menu level
or
accept parameter value
Reduce value
Selection forward Increase value
Selection back
Simultaneous operation
→ one menu level back