NORD Drivesystems BU0750 - Manual (Page 81)

7.2 Operating displays
BU 0750 GB-3311 Subject to technical amendments 81
7.2 Operating displays
In the following, the abbreviation FIwill be used for a frequency inverter.
Parameter Setting value / Description / Note
Parameter
set
Available with option
P000 Operating display Always visible
Only with the Option ControlBox according to selection in P001.
The operating parameter selected in P001 will be displayed here.
P001 Selection display Always visible
0 ... 17
[ 0 ]
0 = Actual frequency [Hz], is the actual output frequency being supplied by the FI.
1 = Speed [rpm], the actual speed calculated by the FI.
2 = Setpoint frequency [Hz], the output frequency equivalent to the actual setpoint. This need not
match the actual output frequency.
3 = Current [A], the actual output current measured by the FI.
4 = Torque current [A], the torque developing output current of the FI.
5 = Voltage [Vac], the actual alternating voltage being output by the FI.
6 = Link voltage [Vdc], the FI-internal DC voltage. Amongst other things, this depends on the
level of the mains voltage.
7 = cos

, the actual calculated value of the power factor.
8 = Apparent power [kVA], the actual apparent power calculated by the FI.
9 = Effective power [kW], the actual effective power calculated by the FI.
10 = Torque [%], the actual torque calculated by the FI.
11 = Field [%], the actual field in the motor calculated by the FI.
12 = Operating hours [h], time that voltage is applied to the FI network.
13 = Enabled operating hours [h], time that the FI is enabled.
14 = Analog input 1 [%] *, actual value present at analog input 1 of the FI.
15 = Analog input 2 [%] *, actual value present at analog input 2 of the FI.
16 = Position setpoint **, desired control position.
17 = Actual position **, actual position of the drive.
*) Only advisable if the customer unit has the appropriate inputs.
**) Only with special extension PosiCon.
P002 Factor display Always visible
0.01 ... 999.99
[ 1.00 ]
The operating value in parameter P001 >Selection of operating value display< is scaled with the scaling
factor and displayed in P000. It is therefore possible to display system-specific operating values such
as bottles per hour.