Festo Контроллеры двигателя CMMS-ST - Manual (Page 13)

2. Safety instructions for electric drives and controllers
Festo.P.BE-CMMS-ST-G2-HW-EN 1008NH 13
2.2 General Information
Festo AG & Co.KG is not liable for damage caused by failure to observe the warning
instructions in these operating instructions.
Note
Before commissioning, the Safety instructions for electric drives
and controllers must be read from page 12 and the chapter 6.5
Instructions on safe and EMC-compliant
installation page 114.
If the documentation in the language in question cannot be understood fully, please
contact your vendor and inform them.
In order for the stepping motor controller to operate without problems and safely, it must
be transported, stored, mounted, planned properly and correctly, taking the risks and
protection and emergency measures into account, as well as operated and maintained
with due care.
Note
Only trained and qualified personnel should be allowed to handle
the electric systems.
Trained and qualified personnel
For the purpose of this manual and the warning instructions on the product itself,
technicians working with this product must be adequately familiar with the setting up,
mounting, commissioning and operation of the product as well as with all warnings and
precautionary measures in accordance with the operating instructions in this product
manual, and must be sufficiently qualified for this task:
- Training and instructions on or authorization to switch on and switch off
devices/systems in accordance with technical safety standards, and to earth and mark
them appropriately in accordance with the application requirements.
- Training or instructions in using and maintaining suitable safety equipment in
accordance with technical safety standards.
- Training in first aid.
The following instructions must be read before the system is commissioned for the first
time to prevent injury and/or material damage:
These safety instructions must be observed at all times.