Festo Контроллеры двигателя CMMS-ST - Manual (Page 29)

3. Product description
Festo.P.BE-CMMS-ST-G2-HW-EN 1008NH 29
Necessary I/O triggering during synchronisation via FCT
- DIN4 Output stage enable
- DIN5 Controller enable
- DIN6 Limit switch 0
- DIN7 Limit switch 1
Required I/O triggering during synchronisation via mode switchover with
24 VDC frequency signals
The connection plan shows the switch position in the active operating state.
*) The limit switches are set by default to opener (configuration over FCT)