Festo Контроллеры двигателя CMMS-ST - Manual (Page 136)

C. INDEX
136 Festo.P.BE-CMMS-ST-G2-HW-EN 1008NH
N
Normal operation
restoration........................................ 95
Note
General information.......................... 13
Safety ............................................... 12
Symbols............................................ 12
O
Open loop............................................ 48
Operating modes................................. 48
Operation mode switchover
timing ............................................... 50
Overview of interfaces ......................... 25
P
PNOZ X2P ............................................ 81
PNOZ XV2P .......................................... 81
Position set table........................... 65, 71
Positioning
I/O connection.................................. 53
Positioning controller .......................... 52
PROFIBUS
Documentation................................. 10
R
Record linking
I/O connection.................................. 74
timing ............................................... 75
Resonance ........................................... 51
S
Safe Stop 1 .......................................... 81
Safe Torque OFF .................................. 81
Safety instructions......................... 12, 15
Scope of delivery ................................. 11
SS1 ...................................................... 81
Step criteria ......................................... 72
STO...................................................... 81
Stop category ...................................... 81
Switching off of enable
timing ............................................... 62
Switch-on sequence
timing ............................................. 119
Synchronisation................................... 27
activate............................................. 28
I/O connection............................ 29, 30
timing ............................................... 31
T
Timing
homing run ....................................... 57
jog / teach ........................................ 69
record linking ................................... 75
switching off of enable ..................... 62
switch-on sequence........................ 119
synchronisation................................ 31