ADTRAN 5000 Series - Manual (Page 10)

Command Reference Guide Using CLI Shortcuts
61200990L1-35E Copyright © 2005 ADTRAN 10
Using CLI Shortcuts
The ADTRAN CLI provides several shortcuts which help you configure your AOS product more easily.
See the following table for descriptions.
Line specifying a line (console or Telnet)
while at the Global Configuration mode
prompt.
For example:
>enable
#config term
(config)#line console 0 (config-con0)# • configure the
console terminal
settings (datarate,
login password, etc.)
• create Telnet logins
and specify their
parameters (login
password, etc.)
Router entering router rip or router ospf
while at the Global Configuration mode
prompt.
For example:
>enable
#config term
(config)#router rip (config-rip)# • configure RIP or
OSPF parameters
• suppress route
updates
• redistribute
information from
outside routing
sources (protocols)
Interface specifying an interface (T1, Ethernet,
Frame Relay, ppp, etc.) while in the
Global Configuration mode.
For example:
>enable
#config term
(config)#int eth 0/1 (config-eth 0/1)#
(The above prompt is for the
Ethernet LAN interface located
on the rear panel of the unit.)
• configure
parameters for the
available LAN and
WAN interfaces
Shortcut Description
Up arrow key To re-display a previously entered command, use the up arrow key. Continuing to press the
up arrow key cycles through all commands entered starting with the most recent
command.
<Tab> key Pressing the <Tab> key after entering a partial (but unique) command will complete the
command, display it on the command prompt line, and wait for further input.
Mode Access by... Sample Prompt With this mode you
can...