ADTRAN 5000 Series - Manual (Page 82)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 82
configure [memory | network | overwrite-network | terminal]
Use the configure command to enter the Global Configuration mode or to configure the system from
memory. Refer to Global Configuration Mode Command Set
on page 281 for more information.
Syntax Description
memory Configures the active system with the commands located in the default
configuration file stored in NVRAM.
network Configures the system from a TFTP network host.
overwrite-network Overwrites NVRAM memory from a TFTP network host.
terminal Enters the Global Configuration mode.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example enters the Global Configuration mode from the Enable mode:
>enable
#configure terminal
(config)#