ADTRAN 5000 Series - Manual (Page 31)

Command Reference Guide Common Commands
61200990L1-35E Copyright © 2005 ADTRAN 31
description <text>
Use the description command to identify the specified interface (for example, circuit ID, contact
information, etc.).
Syntax Description
<text> Identifies the specified interface using up to 80 alphanumeric characters.
Default Values
No defaults required for this command.
Applicable Command Modes
Applies to all interface mode command sets.
Applicable Platforms
Applies to all AOS products.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example enters comment information using the description command:
(config)#interface t1 1/1
(config-t1 1/1)#description This is the Dallas office T1