ADTRAN 5000 Series - Manual (Page 1171)

Command Reference Guide Route Map Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1171
R OUTE M AP C OMMAND S ET
To activate the Route Map Interface Configuration mode, enter the route-map command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#route-map MyMap permit 100
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
match as-path <name> on page 1172
match community <name> [exact-match] on page 1173
match ip address <access list name> on page 1174
match ip address prefix-list <prefix-list name> on page 1175
match ip dscp [<value> | afxx | csxx | default | ef] on page 1176
match ip precedence [<value> | critical | flash | flash-override | immediate | internet | network |
priority | routine] on page 1177
match metric <value> on page 1178
match length <minimum> <maximum> on page 1179
set as-path prepend [<number> | last-as <number>] on page 1180
set comm-list <name> delete on page 1181
set local-preference <value> on page 1182
set metric <value> on page 1183
set default interface <interface type> <interface id> on page 1184
set interface <interface type> <interface id> on page 1185
set ip default next-hop <ip address> on page 1186
set ip df on page 1187
set ip dscp [<value> | afxx | csxx | default | ef] on page 1188
set ip next-hop <ip address> on page 1189
set ip precedence [<value> | critical | flash | flash-override | immediate | internet | network | priority |
routine] on page 1190