ADTRAN 5000 Series - Manual (Page 967)

Command Reference Guide Tunnel Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 967
T UNNEL C ONFIGURATION C OMMAND S ET
To activate the Tunnel Configuration mode, enter the interface tunnel command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface tunnel 1
(config-tunnel 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 968
bandwidth <value> on page 971
crypto map <mapname> on page 972
dial-backup commands begin on page 974
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 990
ip commands begin on page 992
keepalive <period> <retries> on page 1016
lldp receive on page 1017
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 1018
mtu <size> on page 1020
tunnel checksum on page 1021
tunnel destination <ip address> on page 1022
tunnel key <value> on page 1023
tunnel mode gre on page 1024
tunnel sequence-datagrams on page 1025
tunnel source [<ip address> | <interface>] on page 1026