Router (pim sparse) configuration command set, Router (pim sparse) configuration command set 9, Pim s – ADTRAN 5000 Series User Manual
Page 1129

Command Reference Guide
Router (PIM Sparse) Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1129
R
OUTER
(PIM S
PARSE
) C
ONFIGURATION
C
OMMAND
S
ET
To activate the Router (PIM Sparse) Configuration mode, enter the router pim-sparse command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router pim-sparse
(config-pim-sparse)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
join-prune-msg-interval <seconds>
rp-address <ip address> access-group <access-list-name>