ADTRAN 5000 Series - Manual (Page 675)

Command Reference Guide Demand Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 675
lldp send [management-address l port-description l
system-capabilities l system-description l system-name l
and-receive]
Use the lldp send command to configure this interface to transmit LLDP packets or to control the types of
information contained in the LLDP packets transmitted by this interface.
Syntax Description
management-address Enables transmission of management address information on this interface.
port-description Enables transmission of port description information on this interface.
system-capabilities Enables transmission of this device’s system capabilities on this interface.
system-description Enables transmission of this device’s system description on this interface.
system-name Enables transmission of this device’s system name on this interface.
and-receive Configures this interface to both transmit and receive LLDP packets.
Default Values
Be default, all interfaces are configured to transmit and receive LLDP packets of all types.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 9.1 Command was introduced.
Release 11.1 Command expanded to include the demand interface.
Functional Notes
Individual LLDP information can be enabled or disabled using the various forms of the lldp send
command. For example, use the lldp send and-receive command to enable transmit and receive of all
LLDP information. Then use the no lldp send port-description command to prevent LLDP from
transmitting port description information.