ADTRAN 5000 Series - Manual (Page 757)

Command Reference Guide Frame Relay Sub-Interface Config Command Set
61200990L1-35E Copyright © 2005 ADTRAN 757
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Default Values
retransmit-interval <seconds> 5 seconds
transmit-delay <seconds> 1 second
hello-interval <seconds> 10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
dead-interval <seconds> 40 seconds
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 3.1 Command was introduced.
Syntax Description
authentication-key
<password> Assigns a simple-text authentication password to be used by other routers
using the OSPF simple password authentication.
cost <value> Specifies he OSPF cost of sending a packet on the interface. This value
overrides any computed cost value. Range: 165,535.
dead-interval <seconds> Sets the maximum interval allowed between hello packets. If the maximum
is exceeded, neighboring devices will determine that the device is down.
Range: 0 to 32,767.
hello-interval <seconds> Specifies the interval between hello packets sent on the interface. Range: 0
to 32,767.
message-digest-key
<keyid> md5 <key> Configures OSPF Message Digest 5 (MD5) authentication (16-byte
maximum) keys.
priority <value> Sets the OSPF priority. The value set in this field helps determine the
designated router for this network. Range: 0-255.
retransmit-interval
<seconds> Specifies the time between link-state advertisements (LSAs). Range: 0 to
32,767.
transmit-delay <seconds> Sets the estimated time required to send an LSA on the interface. Range: 0
to 32,767.