ADTRAN 5000 Series - Manual (Page 1089)

Command Reference Guide BGP Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1089
BGP C ONFIGURATION C OMMAND S ET
To activate the BGP Configuration mode, enter the router bgp command at the Global Configuration
mode prompt. For example:
>enable
#configure terminal
(config)#router bgp 1
(config-bgp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
All other commands for this command set are described in this section in alphabetical order.
bgp fast-external-fallover on page 1090
bgp log-neighbor-changes on page 1091
bgp router-id <ip address> on page 1092
distance bgp <external> <internal> <local> on page 1093
hold-timer <hold time> on page 1094