ADTRAN 5000 Series - Manual (Page 631)

Command Reference Guide Demand Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 631
D EMAND I NTERFACE C ONFIGURATION C OMMAND S ET
To activate the Demand Interface Configuration mode, enter the interface demand command at the
Global Configuration mode prompt. For example:
#configure terminal
(config)#interface demand 1
(config-demand 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 633
bandwidth <value> on page 636
called-number <DNIS number> on page 637
caller-number <CLID number> on page 638
connect-mode [answer | originate | either] on page 639
connect-order [last-successful | round-robin | sequential] on page 640
connect-sequence on page 641
connect-sequence attempts <value> on page 643
connect-sequence interface-recovery [retry-interval <seconds> | max-retries <value>] on
page 644
crypto map <mapname> on page 645
demand-hold-queue <packets> timeout <seconds> on page 647
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 648