ADTRAN 5000 Series - Manual (Page 624)

Command Reference Guide T3 Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 624
line-length [short | long]
Use the line-length command to configure the line length for a T3 physical interface.
Syntax Description
short Configures the line length for a distance of 0 to 225 feet of cable.
long Configures the line length for a distance of 225 to 450 feet of cable.
Default Value
By default, all T3 interfaces are configured for a short line length.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1 Command was introduced.
Usage Examples
The following example configures the T3 interface for long line length:
(config)#interface t3 1/1
(config-t3 1/1)#line-length long