Ike client command set, Ike client command set 3, Refer to the section – ADTRAN 5000 Series User Manual
Page 1063: Ike c

Command Reference Guide
IKE Client Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1063
IKE C
LIENT
C
OMMAND
S
ET
To activate the IKE Client mode, enter the crypto ike client command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#crypto ike client configuration pool ConfigPool1
(config-ike-client-pool)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
dns-server <address1> <address2>
netbios-name-server <address1> <address2>
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.