Crypto map ike command set, Crypto map ike command set 3, E (refer to – ADTRAN 5000 Series User Manual

Page 1043: This support, Ike c

Advertising
background image

Command Reference Guide

Crypto Map IKE Command Set

61200990L1-35E

Copyright © 2005 ADTRAN

1043

C

RYPTO

M

AP

IKE C

OMMAND

S

ET

To activate the Crypto Map IKE mode, enter a valid version of the crypto map ipsec-ike command at the
Global Configuration mode prompt. For example:

>enable
#configure terminal
(config)#crypto map Map-Name 10 ipsec-ike
(config-crypto-map)#

The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:

cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>

on page 28

description <text>

on page 31

do

on page 32

end

on page 33

exit

on page 34

All other commands for this command set are described in this section in alphabetical order.

antireplay

on page 1044

ike-policy <policy number>

on page 1045

match address <listname>

on page 1046

set peer <address>

on page 1048

set pfs [group1 | group2]

on page 1049

set security-association lifetime [kilobytes | seconds] <value>

on page 1050

set transform-set <setname1 - setname6>

on page 1051

For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.

Advertising