Frame relay sub-interface config command set – ADTRAN 5000 Series User Manual
Page 714

Command Reference Guide
Frame Relay Sub-Interface Config Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
714
F
RAME
R
ELAY
S
UB
-I
NTERFACE
C
ONFIG
C
OMMAND
S
ET
To activate the Frame Relay Sub-Interface Configuration mode, enter the interface frame-relay command
(and specify a sub-interface) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface frame-relay 1.16
(config-fr 1.16)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
dial-backup commands
begin on page 722
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password>
frame-relay commands
begin on page 740
ip commands
begin on page 744
lldp send [management-address l port-description l system-capabilities l system-description l
spanning-tree commands
begin on page 776