Community list command set, Community list command set 1 – ADTRAN 5000 Series User Manual
Page 1111
Advertising

Command Reference Guide
Community List Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1111
C
OMMUNITY
L
IST
C
OMMAND
S
ET
To activate the Community List Configuration mode, enter the ip community-list command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#ip community-list listname
(config-comm-list)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
Advertising