ADTRAN 5000 Series - Manual (Page 16)

Command Reference Guide Basic Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 16
B ASIC M ODE C OMMAND S ET
To activate the Basic mode, simply log in to the unit. After connecting the unit to a VT100 terminal (or
terminal emulator) and activating a terminal session, the following prompt displays:
>
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
enable on page 17
logout on page 18
ping <address> on page 19
show clock on page 21
show snmp on page 22
show version on page 23
telnet <address> on page 24
traceroute <address> on page 25