ADTRAN 5000 Series - Manual (Page 1095)

Command Reference Guide BGP Neighbor Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1095
BGP N EIGHBOR C ONFIGURATION C OMMAND S ET
To activate the BGP Neighbor Configuration mode, enter the router bgp-neighbor command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router bgp-neighbor 192.22.73.101
(config-bgp-neighbor)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-list <listname> [in | out] on page 1096
advertisement-interval <seconds> on page 1097
as-path-list <listname> [in | out] on page 1098
ebgp-multihop <hop count> on page 1099
hold-timer <hold time> on page 1100
local-as <as-number> on page 1101
next-hop-self on page 1103
password <password> on page 1104
prefix-list <listname> [in | out] on page 1105
remote-as <as-number> on page 1106
route-map <map-name> [in | out] on page 1107
send-community standard on page 1108
soft-reconfiguration inbound on page 1109
update-source <interface> on page 1110