ADTRAN 5000 Series - Manual (Page 587)

Command Reference Guide Ethernet Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 587
spanning-tree pathcost method [short | long]
Use the spanning-tree pathcost command to select a short or long method used by the spanning-tree
protocol.
Syntax Description
short Specifies 16-bit values when calculating pathcosts.
long Specifies 32-bit values when calculating pathcosts.
Default Values
By default, spanning-tree pathcost is set to short.
Applicable Platforms
This command applies to the NetVanta 1000, 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example specifies that the spanning tree protocol use a long pathcost method:
(config)#spanning-tree pathcost method long