Line (console) interface config command set – ADTRAN 5000 Series User Manual
Page 470

Command Reference Guide
Line (Console) Interface Config Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
470
L
INE
(C
ONSOLE
) I
NTERFACE
C
ONFIG
C
OMMAND
S
ET
To activate the Line (Console) Interface Configuration mode, enter the line console 0 command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line console 0
(config-con 0)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
accounting commands [<level> l <name> l default]
authorization commands [<level> l <name> l default]
flowcontrol [none | software in]
login authentication <aaa login list>