Router (rip) configuration command set, Router (rip) configuration command set 4, Rip) c – ADTRAN 5000 Series User Manual
Page 1134

Command Reference Guide
Router (RIP) Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1134
R
OUTER
(RIP) C
ONFIGURATION
C
OMMAND
S
ET
To activate the Router (RIP) Configuration mode, enter the router rip command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router rip
(config-rip)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
network <address> <subnet mask>
redistribute connected [metric <value>]
redistribute ospf [metric <value>]