ADTRAN 5000 Series - Manual (Page 509)

Command Reference Guide DSX-1 Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 509
test-pattern [ones | zeros]
Use the test-pattern command to activate the built-in pattern generator and begin sending the specified
test pattern. This pattern generation can be used to verify a data path when used in conjunction with an
active loopback. Use the no form of this command to cease pattern generation.
Syntax Description
ones Generates a test pattern of continous ones.
zeros Generates a test pattern of continous zeros.
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example activates the pattern generator for a stream of continuous ones:
(config)#interface t1 1/2
(config-t1 1/2)#test-pattern ones