ADTRAN 5000 Series - Manual (Page 436)

Command Reference Guide Global Configuration Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 436
radius-server
Use the radius-server command to configure several global RADIUS parameters. Most of these global
defaults can be overridden on a per-server basis.
Variations of this command include the following:
radius-server challenge-noecho
radius-server deadtime <minutes>
radius-server enable-username <name>
radius-server key <key>
radius-server retry <attempts>
radius-server timeout <seconds>
Syntax Description
challenge-noecho Turns off echoing of user challenge-entry. When echo is turned on, users
see the text of the challenge as they type responses. Enabling this option
hides the text as it is being entered.
deadtime <minutes> Specifies how long a RADIUS server is considered dead once a timeout
occurs. The server will not be tried again until after the deadtime expires.
enable-username <name> Specifies a username to be used for enable authentication.
key <key> Specifies the shared key to use with a RADIUS server.
retry <attempts> Specifies how many attempts to make on a RADIUS server before marking
it dead.
timeout <seconds> Specifies how long to wait for a RADIUS server to respond to a request.
Default Values
challenge-noecho By default, echo is turned on.
deadtime 1 minute
key No default
retry 3 attempts
timeout 5 seconds
enable-username $enab15$
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.