ADTRAN 5000 Series - Manual (Page 36)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 36
E NABLE M ODE C OMMAND S ET
To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password
has been configured, a password prompt will display.) For example:
>enable
Password: XXXXXXX
#
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
clear commands begin on page 38
clock auto-correct-dst on page 76
clock no-auto-correct-dst on page 77
clock set <time> <day> <month> <year> on page 78
clock timezone <text> on page 79
configure [memory | network | overwrite-network | terminal] on page 82
copy <source> <destination> on page 83
copy console <filename> on page 84
copy flash <destination> on page 85
copy <filename> interface <interface> <slot/port> on page 86
copy tftp <destination> on page 87
copy xmodem <destination> on page 88
debug commands begin on page 89
dir on page 141
dir [<input> | flash | flash <input>] on page 142
disable on page 143
enable on page 144
erase [<filename> | startup-config] on page 145
events on page 146
exception report generate on page 147
logout on page 148
ping <address> on page 149
reload [cancel | in <delay>] on page 151
show commands begin on page 152