ADTRAN 5000 Series - Manual (Page 1185)

Command Reference Guide Route Map Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1185
set interface <interface type> <interface id>
Use the set interface command to specify an output interface for the packet. Multiple interfaces can be
specified. The router forwards the packet along the first usable interface. Use the no form of this command
to cancel output from the specified interface.
Syntax Description
<interface> Sets output interface type for the packet. Type set interface ? for
a list of valid interfaces.
<interface id> Specifies the ID of the specified interface type.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 Series, and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example sets the output interface as PPP 1:
(config)#route-map MyMap permit 100
(config-route-map)#set interface ppp 1