ADTRAN 5000 Series - Manual (Page 599)

Command Reference Guide HSSI Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 599
HSSI I NTERFACE C ONFIGURATION C OMMAND S ET
To activate the HSSI Interface Configuration mode, enter the interface hssi command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface hssi 1/1
(config-hssi 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
external-loopback-request on page 600
loopback [dce | dte | line | remote | none] on page 601
snmp trap link-status on page 602